I am fitting a system 11 lock on my Taxi. When I bought Taxi it had none of the backbox lock mechanism parts but have since sourced new and used parts and having issues getting it all set up correctly.
The only configuration I have managed to get to work is when the lock thinks its in the open state (i.e. you can remove the key from the barrel) but the bar is in the raised closed position therefore I would need to leave the keys in to stop the back glass from sliding out), I have flipped things around including the position of the barrel in the end plate and the cam but no joy, spent approx 1hr last night on it too.
Anyone encountered a similar situation, spot any mistakes in the photos?
The lock is a new one from Phil or Andy, can I prise off the end of the barrel to change the open and close states?
I was also thinking moving the back box endplate 45 degrees see if that would work but I thought I'd best check there isn't a better solution first or verify any mistakes.
Regards
Chris
The only configuration I have managed to get to work is when the lock thinks its in the open state (i.e. you can remove the key from the barrel) but the bar is in the raised closed position therefore I would need to leave the keys in to stop the back glass from sliding out), I have flipped things around including the position of the barrel in the end plate and the cam but no joy, spent approx 1hr last night on it too.
Anyone encountered a similar situation, spot any mistakes in the photos?
The lock is a new one from Phil or Andy, can I prise off the end of the barrel to change the open and close states?
I was also thinking moving the back box endplate 45 degrees see if that would work but I thought I'd best check there isn't a better solution first or verify any mistakes.
Regards
Chris