Silly little question:
I'm scratch building a VPin body out of 18mm ply, it's 210mm shorter front to rear than a normal cabinet and 50mm shorter top to bottom at the back of the cabinet, however it is the normal (400mm to the top of the wood) at the front.
I'm going to cut out the hole for the coin door next, and while I have the lockdown bar (WPC/WPC95 style) I don't yet have a receiver so I'm not quite sure where make the hole to ensure everything fits
How close to the top of the coin door does the receiver get, are the lugs from the lockdown bar supposed to be level with the top of the coin door hole?
Can anyone send me a pic of one in place on WPC game and/or the measurements of the lockdown bar from top to bottom
Cheers
I'm scratch building a VPin body out of 18mm ply, it's 210mm shorter front to rear than a normal cabinet and 50mm shorter top to bottom at the back of the cabinet, however it is the normal (400mm to the top of the wood) at the front.
I'm going to cut out the hole for the coin door next, and while I have the lockdown bar (WPC/WPC95 style) I don't yet have a receiver so I'm not quite sure where make the hole to ensure everything fits
How close to the top of the coin door does the receiver get, are the lugs from the lockdown bar supposed to be level with the top of the coin door hole?
Can anyone send me a pic of one in place on WPC game and/or the measurements of the lockdown bar from top to bottom
Cheers
