Hi Guys,
hoping you can help me out with this, bought this a few weeks ago, have taken it apart and cleaned it inside and out. putting it back together now.
Originally a load of lights where out, needed an eject hole switch and the eject mech itself wasnt working. a bumper light is broken too and a few fuses out. I changed a load of other stuff like legs, side rails, plastics etc anyways.
last week while working on it i had this loud humming noise. i tracked it down to the wrong bulb in one spot. changed that and the hum was gone. all good.
today i fixed the eject hole lever for video mode etc, it was pretty much just stiff so cleaned it down etc. and its working great. but when i turned the machine back on its making this loud hum again. ive gone around removing loads of lights from and turning it on testing but the noise is still there. I didnt touch anything today before it started other than the eject hole assembly thing and the coil, removing them.
If i remove the cables from the sound board it goes away. Is it an earth issue? ive checked from the earth on the plug to various parts of the pin and it gets connectivity on my meter.
any help appreciate.. video of the humming noise below.
hoping you can help me out with this, bought this a few weeks ago, have taken it apart and cleaned it inside and out. putting it back together now.
Originally a load of lights where out, needed an eject hole switch and the eject mech itself wasnt working. a bumper light is broken too and a few fuses out. I changed a load of other stuff like legs, side rails, plastics etc anyways.
last week while working on it i had this loud humming noise. i tracked it down to the wrong bulb in one spot. changed that and the hum was gone. all good.
today i fixed the eject hole lever for video mode etc, it was pretty much just stiff so cleaned it down etc. and its working great. but when i turned the machine back on its making this loud hum again. ive gone around removing loads of lights from and turning it on testing but the noise is still there. I didnt touch anything today before it started other than the eject hole assembly thing and the coil, removing them.
If i remove the cables from the sound board it goes away. Is it an earth issue? ive checked from the earth on the plug to various parts of the pin and it gets connectivity on my meter.
any help appreciate.. video of the humming noise below.