Congo Grey Gorrila Issue
- Thread starter RudeDogg1
- Start date
OP
OP
I did that’s what the first result of each pin was which had no pulse
OP
OP
That’s 2 results after each number it looked less confusing on my laptop
OP
OP
Will do when I get home from work is it worth checking the right side to?
OP
OP
No different although I did notice when u first put the prob on the legs pulse quickly flashes once
OP
OP
Nope
OK
So we know the following:
Grounding the tab fires the coil, and only the correct coil right?
The Pre Drive Transistory Checked Out as per my previous checks?
Silly question, do you have continuity between pin 5 and the pre drive transistor?
From Pre Drive to TI102?
Was there any board work on the board in this area when pulled?
So we know the following:
Grounding the tab fires the coil, and only the correct coil right?
The Pre Drive Transistory Checked Out as per my previous checks?
Silly question, do you have continuity between pin 5 and the pre drive transistor?
From Pre Drive to TI102?
Was there any board work on the board in this area when pulled?
OP
OP
I didn’t even test the pre driver I just replaced it while I was replacing the transistor for the flasher.
Will check continuity
Will check continuity
OP
OP
And no no boardwork in that area
OP
OP
No continuity no buz but it is getting a
Reading rather than zeroing out
Reading rather than zeroing out
OP
OP
Tried this morning using the switch and no change
OP
OP
I’ve changed chips before unfortunately I have 4 types of chip in stock and not 1 of em is the correct one grrr lol
OP
OP
Got the pre drive ones already changed that one dunno about the resistors no don’t have any sockets. Although I think I will change em all again just in case, pm incoming
