Hi guys, I have a problem on my Creech, on start up it says pinball missing even though all 3 balls are in the machine. I'm not really into the technical side of things but here are a few things I've noticed.
On start up it does seem to fire the solenoids looking for the balls all apart from the one at the outhole between the flippers, I guess it's the one that returns the ball to the trough after a drain. ( although this does fire in test mode ).
In switch test mode the switches at the outlanes, inlanes & ball trough don't seem to register anything at all when operated manually.
I've looked around for broken wires etc but found nothing, any ideas where to look next would be much appreciated.
I've made a note of test point voltages & led status if any of that can be of help.
Cheers
John
On start up it does seem to fire the solenoids looking for the balls all apart from the one at the outhole between the flippers, I guess it's the one that returns the ball to the trough after a drain. ( although this does fire in test mode ).
In switch test mode the switches at the outlanes, inlanes & ball trough don't seem to register anything at all when operated manually.
I've looked around for broken wires etc but found nothing, any ideas where to look next would be much appreciated.
I've made a note of test point voltages & led status if any of that can be of help.
Cheers
John