Hi Folks,
This is where I currently am with the help of a good forum friend on whatsapp, Not sure of your forum name but thanks for the continued help for several weeks on this carl!
When I now go into test mode and manually test the motor, I Can hear the relay clicking in and out when it goes to on or off, but the motor does still not spin.
focusing on the motorhead board now :
When I test for 20v at the motorhead board, by putting red probe on J1 and black on J1-2 I get -23.5 (yes minus)
When I put red probe on J2 pin 1 and black on a braided wire I get 12.9V (NOT A MINUS)
Testing across pin 2 and pin3 on J2 I get -12.9 (MINUS AGAIN)
Testing across pin 1 on J2 and pin 2 on J1 I get 10.3 (NO MINUS)
Testing pin 1 on J2 and 2 on J1 I get -12.9 (again a minus)
So it seems that 20V and I am getting 12V out which appears to be fine, not sure when is im getting a minus and not sure when the motor isn't spinning?
Do we think that the regulator board is fine, and I should now move onto testing the relay board?