As the tittle says - the White Water has been done.
Outline of work carried out:
Cabinet metal-work blue powdercoat
Rad Cals fitted
New lockdown bar retainer
PinLED 'Fliptronics' board installed
Pinsound Plus board installed (with 3 sound packages you can switch between)
Pinsound 2.1 stereo speakers with genuine loom
Pinsound subwoofer
Pin2DMD display with Endproduk's colourisation installed
Eprom LH6
CPU board has CR2032 button cell fitted (no battery leak on board)
Brand new playfield
Brand new mini playfield
New target switches
New boulders
New ramps
New flipper coils
New flipper parts
New flipper plates
New coin door
COMET LEDs fitted in GI on backbox and behind backglass
Proper GLASS 'Backglass' by @xianek
New speaker panel plastic (still has protective layer on it)
All LEDs fitted under inserts
All but one flasher is LED
SIde 'artwork' supplied but not fitted as I do not like the look of it!
Lasercut 'W' logos for speakers also supplied (yes I think these dont look great either)
Numerous new plastics, and an aditional Whirlpool plastic (as I ordered the wrong one for Bigfoot!) - this will need ordering from Ministry of pinball
New Start button
New upkicker welderment
New slings with Colin's protecter washers
New plunger with blue end
New decals on apron
Remake topper
All new lamps in the topper (the correct ones!) - I did not replace these with 12v LEDs as they do not look right
Rakes of new coils and switches etc....
Outline of work carried out:
Cabinet metal-work blue powdercoat
Rad Cals fitted
New lockdown bar retainer
PinLED 'Fliptronics' board installed
Pinsound Plus board installed (with 3 sound packages you can switch between)
Pinsound 2.1 stereo speakers with genuine loom
Pinsound subwoofer
Pin2DMD display with Endproduk's colourisation installed
Eprom LH6
CPU board has CR2032 button cell fitted (no battery leak on board)
Brand new playfield
Brand new mini playfield
New target switches
New boulders
New ramps
New flipper coils
New flipper parts
New flipper plates
New coin door
COMET LEDs fitted in GI on backbox and behind backglass
Proper GLASS 'Backglass' by @xianek
New speaker panel plastic (still has protective layer on it)
All LEDs fitted under inserts
All but one flasher is LED
SIde 'artwork' supplied but not fitted as I do not like the look of it!
Lasercut 'W' logos for speakers also supplied (yes I think these dont look great either)
Numerous new plastics, and an aditional Whirlpool plastic (as I ordered the wrong one for Bigfoot!) - this will need ordering from Ministry of pinball
New Start button
New upkicker welderment
New slings with Colin's protecter washers
New plunger with blue end
New decals on apron
Remake topper
All new lamps in the topper (the correct ones!) - I did not replace these with 12v LEDs as they do not look right
Rakes of new coils and switches etc....
Last edited: