Whitewater Bigfoot divertor

[Drew.m]

Afternoon, my WH20 bigfoot as suddenly stopped diverting when the bigfoot bluff ramp is accessed, the weird thing is it does divert if the insanity falls entrance is accessed, i have checked the switches and they seem fine and the diverter works (changed u20 just in case) if anyone has any suggestions i would appreciate it.

Drew

 

[Drew.m]

Also changed cpu pcb, still the same, the really weird thing is the switch test indicated the switches are the wrong way round but i have not changed anything on the machine

 

[Drew.m]

I think the switches have been wired the wrong way round on the connector (or the switches are physically the wrong way round if someone could check their canyon entry connection it would really help

 

[CHRIS B PINBALLS]

Go in switch test and check them in there but if it’s only just happened I am not too sure
Easy fix though just swap the switch s round on the entrances they are next too each other someone has probably put them back in the wrong place at some point

 

[Drew.m]

Hi Chris, thanks for that you are right I traced them back and pin 8 & 9 we’re the wrong way round. It’s weird how it suddenly started happening though, the only thing I can think is one of the switches may have been touching a ground so they were both registering previously as the same switch and I hadn’t noticed

once again thank you for the advice

Drew