Useful pop bumper rebuild guide

[Sgt GrizZ]

Pay attention now troops .....Spotted this just now - handy if you have never done it before :confused1:, are plain scared :fear:, or are just crying like a ickle baby at the thought

Good stuff

http://pinside.com/pinball/forum/topic/vids-guide-to-rebuilding-pop-bumpers

 

[ronsplooter]

Was just having a read through that on Pinside....very useful guide :thumb:

 

[Sgt GrizZ]

Was just having a read through that on Pinside....very useful guide :thumb:

Glad I'm not the only one without a life tonight

 

[Paul]

Typical!! Just done mine on the MM to replace some rather warn skirts - Not too difficult a task tho!

I say that - i havent switched it on yet... :scared:

 

[Calimori]

I did one on my TAF before I heard other people say they were tricky. Just found the angle for soldering awkward plus wire to ribbons felt harder. Other than that, they come apart quite easily.

 

[Sgt GrizZ]

I did one on my TAF before I heard other people say they were tricky. Just found the angle for soldering awkward plus wire to ribbons felt harder. Other than that, they come apart quite easily.

Agree. The only PITA bit really is the wiring to the lamps. The fact that they are often at the furthest part of the playfield when you have the pf lifted up doesn't help either.