TZ again

[Kenny Taylor]

On my TZ the ball kicks up on some target posts. Primarily the slot machine, so I thought. However it also does it but not as bad in the million shot between the Ramps and a post next to the town. On closer inspection the foam/rubber behind these target has worn thru. Where would I get replacement foam from?

 

[kevlar]

I bought a roll of foam draft excluder from B&Q and cut pieces of that. Only about £6 I think, enough to do 100 machines probably. Works a treat.

 

[RudeDogg1]

The target is normally bent when u get air balls when you hit them. In my experience it's a waste of time straightening them they will just bend again. So I just replace the whole target. You can also get a reinforced target for the slot machine

 

[Kenny Taylor]

I bought a roll of foam draft excluder from B&Q and cut pieces of that. Only about £6 I think, enough to do 100 machines probably. Works a treat.

That's good to know. What glue did you use?

 

[kevlar]

None, its self adhesive, peel and stick.

 

[Kenny Taylor]

Even better

 

[Kenny Taylor]

Forgot to mention, Phil of Pinball Heaven kindly sent me the correct foam free of charge. Went back with the B&Q stuff