Tilt Topper - TSPP Plug Question

[Darthsinex]

Quick question if anyone can help? I've just bought a Simpsons topper for my TSPP from Tilt Toppers which is very nice, but surprisingly comes with zero installation instructions. The instructions on their website are also next to useless and don't relate to TSPP. The topper comes with a single very long grey wire indicating it's expecting to be connected in the cabinet rather than backbox I'm guessing and it has a single 2 pin Molex on the end. Anyone, any idea where this goes to, or has anyone installed one of these in the past? Any help appreciated

 

[Mozie]

I presume it's 12v? Have a look around the coin door on inside for matching connector should be around there somewhere. If you post a pic of the connector might be handier

 

[Darthsinex]

Absolutely, here are pictures. Looks like all the connectors to the right of the door are being used. But the wire is long enough to feed from the topper all the way to the front of the cabinet as you can see.

 

[Mozie]

You'll need a splitter or splice into the red/black cable into the picture above to nab power from it..

 

[Darthsinex]

Yes, thinking maybe this? https://www.pinballlife.com/stern-12v-and-5v-splitter-harness.html ? Not sure if anyone in UK sells these?

 

[Fantazia2]

The connectors themselves are generic so if you can get the part numbers you should be able to get the parts and make your own up for cheaper.

I think pinball mania may possibly stock the connectors and pins.

 

[Mozie]

Yes that one will do the job albeit at an expensive