Taf flipper no hold

[glyn davies]

I have a taf and the right bottom flipper wont hold it stutters

Ive had the board tested and new coil but still doing it

Any thoughts

 

[Pick Holder]

Eos switch ?!?

Do a switch test and manually activate eos

Then move the flipper manually and see if it still activates.

 

[glyn davies]

In switch test mode yes it registers

 

[pinballmania]

Incorrect return spring (overly strong) ?

 

[glyn davies]

Just took speing off to try n still bouncers

 

[DAFlippers]

Flipper hold driver fault, broken hold wire or coil.

David

 

[glyn davies]

Its had new coul
Its had flipper board tested

 

[DAFlippers]

Have you checked (measured) the connection from the board to the hold on the coil?

What happens if you earth the hold tab?

David

 

[glyn davies]

This is what happens

 

[glyn davies]

Which is the hold wire is that the orage

 

[glyn davies]

When i put it in flipper test mode on the working side i can hear it engize the hold test on none working side in flipper hold mode there nothing

 

[DAFlippers]

Go to flipper hold test and that should tell you wire colour. Also compare flipper hold test on L and R flippers - move flipper by hand to top position and see if it is being held during test.

 

[DAFlippers]

if not energising during hold test the the problem is the Fliptronics board, the loom or the coil. If you earth the hold tag then the coil is good so work back from there.

 

[glyn davies]

Fixed it

 

[glyn davies]

Dirty plastic connector

 

[glyn davies]

Thank for all you help