Red & Ted go on strike

[Paul R Owen]

Playing Roadshow last night during multi-ball, loads of jackpots when suddenly Red stopped registering hits, shortly followed by Ted (the bulldozer blade). I have checked the eddy-sensors but they still don’t register hits. Has anyone any ideas why both should stop working at the same time?

 

[Moonraker]

Have you checked your fuses? Then go into the switch matrix and see if you have a row or column line out or part working - if part working look for a wire off in between the working and no working section. You could also check the connectors in the back box to see if any have worked loose. Good Luck!

 

[Paul R Owen]

Have you checked your fuses? Then go into the switch matrix and see if you have a row or column line out or part working - if part working look for a wire off in between the working and no working section. You could also check the connectors in the back box to see if any have worked loose. Good Luck!

The problem is I cannot fathom which fuse to check?

 

[Moonraker]

Look in the manual, if you haven't got one then download it from IPDB...

 

[Paul R Owen]

Look in the manual, if you haven't got one then download it from IPDB...

I did read the manual last night but couldn't make any sense of it, I have not come across this error before!

 

[Moonraker]

Oh and also check the Feature Adjustment settings to see if they've been set to OFF...

 

[Moonraker]

Assuming it is a switch issue ( has you tested if they register on the switch matrix first?) then Fuse list is on page 1-44 (56/148) - the solenoid table is on page 2/148 - I'd check Fuses 115, 116 for switches. If the switches are registering on the switch matrix then look at fuses 104, 112 for solenoids.