Hi guys
Fairly new to pinball. I have just bought a Williams Dirty Harry and used to have a Gameplan Sharpshooter which I tuned up a few years ago. It was all a stab in the dark on the SS and I got it working pretty well but the DH seems a little more complicated.
DH is in general working order and I've done some basics like change lamps, cleaning and a couple of plastics. Even changed a burnt out connector (J120). But, I've noticed a couple of niggles that are beyond me and looking for some advice.
The gun doesn't always catch the ball and sometimes rolls out. It will stay at 90 degrees. Is there a magnet that catches the ball too?
The top gate also sticks and sometimes stays up.
Is there any tips for servicing coils?
I also need to change a couple of targets and bullet plastic but these appear to be riveted on. Any tips on replacing?
Does anyone have any other general advice that would be helpful to a noobie?
Thanks
Fairly new to pinball. I have just bought a Williams Dirty Harry and used to have a Gameplan Sharpshooter which I tuned up a few years ago. It was all a stab in the dark on the SS and I got it working pretty well but the DH seems a little more complicated.
DH is in general working order and I've done some basics like change lamps, cleaning and a couple of plastics. Even changed a burnt out connector (J120). But, I've noticed a couple of niggles that are beyond me and looking for some advice.
The gun doesn't always catch the ball and sometimes rolls out. It will stay at 90 degrees. Is there a magnet that catches the ball too?
The top gate also sticks and sometimes stays up.
Is there any tips for servicing coils?
I also need to change a couple of targets and bullet plastic but these appear to be riveted on. Any tips on replacing?
Does anyone have any other general advice that would be helpful to a noobie?
Thanks
Last edited: