No fear ball launch / setup.

[Toxic frog]

On no fear when you first turn the machine on it sets the balls up by launching a ball up the playfield into a sink hole. Problem is the ball rarely goes into the sink hole and its keeps shooting balls about 5 times until it gives up. The other annoying thing about this is that often when it rolls back it goes straight between the flippers.

I cant see anyway of adjusting this, any ideas?

Also the left flipper is a little slow to respond. If I am holding the left flipper with two balls sitting on it and want to separate the balls, releasing the button and quickly pressing it again often doesnt make the flipper move at all unlike the right flipper, again any ideas?

 

[Paul]

Have you got it set at the right angle? Does it go in the hole, however doesnt make it all the way up and comes back down again??

Sounds like it's too steep to me

 

[Moonraker]

This is an easy one, once you know how....

Check to see if the ball is resting on the launch plunger tip. It shouldn't. Pull (bend) the metal housing forward so there is a 1/4 to 1/2 inch gap between the ball and the plunger tip.