I bought some clear rubbers for my Avatar (because it is so damn pretty) and found that the lane guide rubbers are a barsteward to fit so after a lot of swearing I came up with an easy way to fit them.
Cut the pocket clip from a Sharpie pen top.
Put the rubbers in dome hot water for a couple of minutes.
Slide the rubber onto the pen top.
Put the pen top over the lane guide and then slide the rubber onto the guide.
Cut the pocket clip from a Sharpie pen top.
Put the rubbers in dome hot water for a couple of minutes.
Slide the rubber onto the pen top.
Put the pen top over the lane guide and then slide the rubber onto the guide.