Hex spacers or whatever they're called - best source?

[Mfresh]

Anyone have any idea where the best place to get hex spacers is? PH doesn't have any and I can't see what I'm after on Andy N's site either.

I need the two hex spacers that hold up the TZ wireform above the slot machine scoop. I think the part numbers are
02-4335-8
02-4436-10
02-4611-3

Best of Pinball.de seems to have one of these, but in general is it necessary to go to a US based supplier?

Thanks!

 

[BigIan]

Did you try emailing Andy as he has loads more stuff than listed on his site.

Or Maybe Dave at pinballdaze, he has some hard to find stuff also.

I would call them stand offs if they have a bolt sticking out and a spacer if female threaded at both ends

 

[Mfresh]

Thanks BigIan. I've emailed Andy so fingers crossed he might have them.

And thanks for the info about names. They were both standoffs, but the bolt sticking out of the top one has sheared off and is stuck in the bottom one. So they are no longer standoffs. Ex standoffs I suppose....

 

[cooldan]

Failing that, is any of this any good?
No idea where it came from but you can have it if you want

 

[Moonraker]

Failing that, is any of this any good?
No idea where it came from but you can have it if you want

They look like the spacers that DE/Sega use on the back of the DMD panel to hold the DMD controller/driver PCB on to it.

 

[BigIan]

Yeah look like data east dmd standoff to me too.

 

[Mfresh]

Thanks for the offer Dan, but they look too small to me (unless you have enormous hands.) The ones I am after have a theaded bit poking out at one end and lengthwise the hexagonal bits need to be about 1.4 inches long for one and the other about 2.1 inches long.

Thanks for the offer though - much appreciated