DMD driver resetting game (roadshow)

[Cryptkeeper]

OK,
so got my cpu repaired by luke and now it wont boot with the driver board connected.
Any ideas before I go digging?
I disconnected the power to the DMD driver and it still wont boot with the ribbon connected.

 

[Pudsey pinball]

You need to recheck all you ribbon cables and all connections to all boards

 

[Cryptkeeper]

Cheers,
I swapped out the board with my whitewater and the board tests good.
also swapped the ribbon cable and that tested good.
I have no idea

 

[Cryptkeeper]

OK!
Its working.
must of been a loose connector!

 

[Pudsey pinball]

You ribbons correct way around I.e red on ribbon to pin 1 on boards,make sure all connectors are on pins correctly

 

[Pudsey pinball]

There ya go!!!!!

 

[Cryptkeeper]

Well the game is back in action,
I fought it for a few hours and encountered a few phantom problems that I never quite figured out.
At one stage I had no DMD,
Then no sound,
the the flippers were locking on blowing a fuse.
Then I had all different combinations of the above problems

I suspect it was an issue with the cable/headers on ribbon from the cpu/fliptronic/sound/display I/O line but I was unable to prove it.
Have a pinsound installed and no more Carleane Carter multiball!
Nice bit of kit but still has some bugs in the firmware.

Big thanks to LukeWells too.
Top bloke

 

[RudeDogg1]

Have u tried reseating the cables?

 

[Cryptkeeper]

Its all working now.
reseated cables a million times!