What's new
Pinball info

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Dialed In boot issue

Run.dll

Registered
Joined
Jul 3, 2023
Messages
29
Location
Newport
Hello,

I'm having a booting issue with my JJP Dialed In. I think the cmos battery died as when I switched on the game the main lcd screen didn't turn on and the phone had the 'settings lost press F1 for setup or F2 to continue' screen.

I've now replaced the battery and entered the bios and set the date and time. I've also made sure the 'restore after ac power loss' option is enabled however it still won't boot and the main screen just goes into standby.

I tried updating the game and the installation was successful however it was all done via the tiny phone screen. I'm getting the error shown in the picture below. Please can anybody help? Thanks.

**please ignore the vga EDID errors at the bottom. That's just where I've had to plug in a monitor on the phone vga cable to be able to read the text. The game doesn't boot even then the phone is plugged in correctly **signal-2024-12-01-11-43-35-211.webp
 
Did you do the full installation or an update? Would need a full installation I think to set the bios up again.
I’m going by a similar thing that happened on my spooky game with a pc.
 
Did you do the full installation or an update? Would need a full installation I think to set the bios up again.
I’m going by a similar thing that happened on my spooky game with a pc.

Thanks for your reply. I downloaded the full installation iso from the JJP website. I put the stick into the usb by the coin door and the game automatically applied it so I assume it re-wrote the whole installation. I'm not certain about that though. It didn't change any of the bios settings when it installed.
 
Back
Top Bottom