I've got a DESW that I'm trying to resurrect, Andy Netherwood came a while ago and got everything else working but thought it needed a new flipper board as both flippers were dead.
I was expecting one to be dead as I had swapped this board with one from LW3 years ago when one flipper stopped working on LW3. I was a bit surprised that both were dead but figured I might be remembering it wrong so I've got a replacement flipper board and put that in but still no good. Both flippers still dead. So, I don't think it's the flipper board, although I'm planing on confirming this by trying the flipper boards in LW3 but that is at my mates house so I can't do it until later in the week.
Both flipper switches are working, because I can see them when I press the buttons during switch test.
Any ideas what I should try next?
I was expecting one to be dead as I had swapped this board with one from LW3 years ago when one flipper stopped working on LW3. I was a bit surprised that both were dead but figured I might be remembering it wrong so I've got a replacement flipper board and put that in but still no good. Both flippers still dead. So, I don't think it's the flipper board, although I'm planing on confirming this by trying the flipper boards in LW3 but that is at my mates house so I can't do it until later in the week.
Both flipper switches are working, because I can see them when I press the buttons during switch test.
Any ideas what I should try next?