A WPC95 board setup for tracing out an issue with distortion and a high DC offset
As you can see lots of wiring to get the psu's setup right, all commoned to ground, with floating psu configured for +/- 15v with the centre point referenced to ground.
High Speed 2 Accelerator PCB with coil firing issues.
Master PSU reconfigured to series to allow for +50v, commoned to second psu, plus commend to the videogame tester to allow for logic tracing.
Digital DC load configured in resistance mode to simulate a pinball coil and provide the correct load on the accelerator drive transistors

As you can see lots of wiring to get the psu's setup right, all commoned to ground, with floating psu configured for +/- 15v with the centre point referenced to ground.


High Speed 2 Accelerator PCB with coil firing issues.
Master PSU reconfigured to series to allow for +50v, commoned to second psu, plus commend to the videogame tester to allow for logic tracing.
Digital DC load configured in resistance mode to simulate a pinball coil and provide the correct load on the accelerator drive transistors
