Sold Unknown lockdown bar

[Sgt GrizZ]

Mystery lockdown bar ......Not sure what machine / make / era this is from

The width is slightly more than the one on my TAF or WH20.

Tried it on TAF ...it sits on there ok but the latch wont fully enage - enough to hold it but not fully.

Tried on Whirly (Sys 11) - again didn't quite sit right.

Someone might be able to I.D it from the design ??

Its a bit rusty underneath, would clean up. Top side not bad.

£10 + postage if anyone wants it ???

 

[Paul]

Sgt - Deffo interested - let me take a couple of measurements.... Will be back to you in mins...

Edit - Sod it - Will take it anyway if it's still available please mate

 

[paddythegreek]

Bugger
Need one for a sys 11. Oh well next time

 

[Sgt GrizZ]

Sgt - Deffo interested - let me take a couple of measurements.... Will be back to you in mins...

Edit - Sod it - Will take it anyway if it's still available please mate

All yours Paul

 

[Jay Walker]

I'd say that was for an old-time Stern standard width game - is there any part number stamped in the base section, between the two prongs?