What's new
Pinball info

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

NSM Jukebox Keypad Repair

DRD

Registered
Joined
Oct 26, 2014
Messages
5,421
Location
Newark
Does anyone know a good source of the little push-fit plastic cylinders used in nsm keypads pls?

When old, the plastic just disintegrates and the keypad slowly dies

@mark9 @Pick Holder ?

Ta
1544781345189982882682.jpg
 
I cleared a retiring operator store room in June but most juke stuff went straight to ebay however I'll take a look on Saturday as I might have these in a box of small parts . There were over 1000 items from fruit bulbs to a Creech so not everything has been sorted yet
 
  • Like
Reactions: DRD
The bits I need are like little grains of rice. They are probably made of nylon. Perhaps 2mm diameter. 5mm long.

Wooden tooth picks cut to length almost do the job but not quite.

Maybe plastic strimmer line might do it
 
I think the Pad in my jukebox is fine. I cleaned the contacts and the coiled wire spring things ages ago.

It is just the little rubber/ nylon cylindrical pushers that I need.
 
Back
Top Bottom