biglouieuk
Site Supporter
Always been a big Defender fan and while I wait for a cab, I thought I'd make a swappable CP for my Mr Driller cab.
Mr Driller has original PCB and a switcher for an RGP Pi for Jamma.
Fantastic bit of kit. Think I'll laser engrave the Defender CP artwork onto that oak veneered MDF! Only sheet material I had around.
Cut out a control panel, wired up a new harness and connector and wotnot and started to get better at Defender.
CNC machine is all over the place at the moment, holes were 2mm off diameter, so had to revert to drill press and Forsner bit.
Just a bit of fun and a change from pins for a little bit
Mr Driller has original PCB and a switcher for an RGP Pi for Jamma.
Fantastic bit of kit. Think I'll laser engrave the Defender CP artwork onto that oak veneered MDF! Only sheet material I had around.
Cut out a control panel, wired up a new harness and connector and wotnot and started to get better at Defender.
CNC machine is all over the place at the moment, holes were 2mm off diameter, so had to revert to drill press and Forsner bit.
Just a bit of fun and a change from pins for a little bit
