driver board connector bodge !

[Deleted member 3624]

so ive started putting the black rose back together and found this connector bodge - it looks like the 7 way connector on to the secondary output has at some time burnt out pin 1 - hence the single pin on its own - is this the case and if so where can i source a new 7 pin connector from ? found a set of wpc-95 drawings that have this connector with two red cables and two blues in this configuration ?

 

[Mfresh]

https://pinparts.co.uk/products/idc-connector-0156-pitch

 

[Deleted member 3624]

cool - the pins are red - red space blue space blue ? is that correct TA

 

[pinballmania]

Not quite.

Red
Red
Key
Blue/white
Same Blue White looped in
Other Blue White
Other Blue White looped In

It is ESSENTIAL that you put a keying plug in pin 3. If you inadvertently mis connect this connector then the whole section will melt down to the transformer.

 

[Deleted member 3624]

Not quite.

Red
Red
Key
Blue/white
Same Blue White looped in
Other Blue White
Other Blue White looped In

It is ESSENTIAL that you put a keying plug in pin 3. If you inadvertently mis connect this connector then the whole section will melt down to the transformer.

arh yes sorry you can see the loops on the picture - thank you !

 

[chris b]