Hi All,
After the foam tape for lockbar “Beer seal” anyone have any to hand!?
Thanks
After the foam tape for lockbar “Beer seal” anyone have any to hand!?
Thanks
Wanted Beer/ drink Seal
- Thread starter Dave Bishop
- Start date
Believe I have one or two spare mate. How many did you need? Not home until tomorrow though
Sent from my iPhone using Tapatalk
OP
OP
Hi Carl
I’m after 1 length for a Williams standard lockbar please
I’m after 1 length for a Williams standard lockbar please
Yeah pretty sure I have Atleast a spare. here standard I believe. Will dig one out for you when I get home tomorrow mate and pop it in the post. Just pm me details and I will sort it out for ya [emoji106]
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
OP
OP
Thanks Carl, much appreciated
I used this on my TNA and ACNC - https://www.amazon.co.uk/gp/product/B00QAH3MMA/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1.
1mm thick, 10mm wide. This covered the top, side and bottom but it made it too tight so stripped the top off, leaving it on the bottom and side of the glass.
EDIT: Just realised you want it for the lockbar, not the glass, ignore!
1mm thick, 10mm wide. This covered the top, side and bottom but it made it too tight so stripped the top off, leaving it on the bottom and side of the glass.
EDIT: Just realised you want it for the lockbar, not the glass, ignore!
OP
OP
No problem mate. Didn’t realise Andy did them. Good to know for future [emoji106]
Sent from my iPhone using Tapatalk
Pinball mania sell them
I’m assuming Dave you need after powder-coating your lock bar
You may need the Mylar Rectangle also cut to size to protect the side rails which goes either side of underneath lock bar.....
Link to area for rectangle
https://pinparts.co.uk/products/mylar-ring-for-pop-bumper
